Malissa here with a fun lamp for you all this month! The concept here is really similar to my copper pipe lamp and it is really very simple. Just make sure to carefully follow the wiring instructions! And just for those of you wondering how the marble contact paper looks in real life–it looks fantastic! I love the marble contact paper I found and I am sure any brand would look equally great.
– Wood plaque (any shape you want, you can get these at almost any craft store)
– Lamp kit
– Light bulb
– ¼ inch drill bit
– Cardboard tube (from wrapping paper)
– Acrylic bumpers
– Spray paint (optional)
– Super glue
1. Optional: Spray paint the wood plaque.
2. Take the cardboard tube and mark off at how high you want the lamp to be. I did about 12 inches.
3. Cut the tube.
4. Roll out the contact paper and start to peel it off. Place the tube on top and carefully roll it over the paper.
5. As you roll, make sure to get any bubbles out.
6. Cut the contact paper off once the tube is entirely covered. Cut off any excess paper.
7. Take the drill and drill bit and drill a small hole in the middle of the plaque.
8. Next, take the cord and place it through the hole through the bottom.
9. Take the tube and place it over the cord and make sure the cord just peeks out of the tube a little bit.
10. Now take the socket from the lamp kit and use a screwdriver to loosen the screws.
11. Attach the wires to the screws. You will want to take the ribbed wire and wrap it clockwise around the silver screw. Repeat with the other wire on the bronze screw. Make sure that the cord is not plugged in!
12. Place the socket cover on top of the socket.
13. Screw in the light bulb.
14. Now glue the bottom of the tube to the wood base for extra security.
15. Place four bumpers on the bottom of the plaque.
16. Plug in your lamp!
– Malissa (Build Contributor)
click here for more build tutorials.